Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Samsung specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 561-5298 Start a Repair
Model library · Samsung Range

NSI6DG9100SR

Samsung NSI6DG9100SR Smart Induction Repair

Start a Repair(713) 561-5298

Most common issues on this model

  1. Oven hotter than its setting
  2. Convection fan loud or silent
  3. Control board not communicating with the display
  4. Induction zone not heating a pan
  5. Phone preheat not starting

The NSI6DG9100SR is a Bespoke 6.3 cubic-foot smart slide-in induction range in stainless steel, with an anti-scratch glass cooktop. It is all electric and runs on a 240-volt circuit, so it is common in newer kitchens or in homes that moved off gas.

For service, this model sits between a conventional range and a fully smart one: it has the Wi-Fi link and the induction cooktop, but no air fry mode or camera. An oven that runs hotter than set, or a convection fan that is loud or silent, is where we start, then the control board and its link to the display.

We also test each induction zone with a pan that suits induction cooking. Before we order any part we confirm the full model and serial from the label, and you get a written price before we begin. Parts for older models can take longer to find, so we check availability first.

Key features

  • Bespoke 6.3 cu. ft. smart slide-in induction range
  • Anti-scratch glass cooktop
  • Stainless steel finish
  • SmartThings Wi-Fi remote preheat
→Codes

Error codes this model can show

doorSamsung Range Message door: Door Not Closed tESt / tE5tSamsung Range Message tESt or tE5t: Demo Mode u (underlined)Samsung Induction Range Message u: Pan Detection bAd LinESamsung Range Message bAd LinE: Power Connection C-10Samsung Range Code C-10 (Self-Diagnosis): Usually Ignorable C-24Samsung Oven Heating Too Fast: Code C-24 Vent Check C-F0Samsung Range Code C-F0 (Electronics Link): Reset and Update C to PSamsung Range Message C to P: Cooktop In Use
NSI6DG9100SRNSI6DG9100SR questions
Why is the convection fan on my induction range loud?

A worn motor bearing or a bent blade is the usual cause. We check the fan with the back panel off and test its power before we price a motor.

Can you repair a model that is near the end of its run?

Usually yes. We confirm the exact model from the label, check which parts are still in supply, and quote before ordering. If a part is no longer stocked, we tell you before any work and look for a sound alternative.

What if only one induction zone fails?

Each zone has its own coil and power path. We test the zone with a pan that works on induction and then isolate the coil, board or connection that has failed.

Book a visit

Book repair for your NSI6DG9100SR

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 561-5298