Error code · Washer

Samsung Washer Code bE / 6E: Motor Speed Sensor

Medium · inspection needed

Code: bE / 6E
Appliance: Washer
Brand: Samsung
Warranty: 30-day workmanship

What bE / 6E means

Samsung washers with a digital display, front-load and top-load, show bE or 6E when the control cannot read a good signal from the motor speed sensor. The control watches how fast the drum is turning, and without that reading it stops the cycle. This is a different condition from bE2 or 6E2, which are listed for a stuck button. The listing names no models, so it applies to Samsung washers with a numeric display.

Common causes of bE / 6E

Motor speed sensor signal
Sensor wiring and connector at the motor
Motor and drum drag under load
Main board input for the sensor

✓ One safe check you can try

1. Shut the washer off and give it a few minutes. 2. Power it up and run the cycle again. 3. Remove part of the load, since a heavy or lopsided load can make the drum hard to turn. 4. If bE or 6E comes back, schedule a visit and stop using the washer.

! Why to stop there

A restart cannot show whether the sensor, its wiring, or the motor is the cause.
We check the sensor connector and wiring at the motor and test the signal while the drum turns.
We separate this from the button code before anything is quoted.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

Cold / Eco WarmSamsung Washer Cold or Eco Warm Lights Blinking: Stuck Button Extra Large / Extra High / Large / High blinkingSamsung Washer Extra Large, Extra High, Large, or High Lights Blinking: Water Not Filling Hot & Cold / Hot & Eco WarmSamsung Washer Hot and Cold, or Hot and Eco Warm Lights Blinking: Motor Error Hot / Hot & Extra Large / Hot & Extra High / Hot & Large / Hot & HighSamsung Washer Hot, or Hot with a Level Light Lights Blinking: Door Not Locked Hot & Medium / Hot & MidSamsung Washer Hot and Medium, or Hot and Mid Lights Blinking: Heater Error Hot & Small / Hot & LowSamsung Washer Hot and Small, or Hot and Low Lights Blinking: Hoses Swapped Hot & Tap Cold / Hot & CoolSamsung Washer Hot and Tap Cold, or Hot and Cool Lights Blinking: MEMS Sensor Error Hot & WarmSamsung Washer Hot and Warm Lights Blinking: Unbalanced Load

bE / 6EbE / 6E questions

Is bE the same as bE2?

No. bE and 6E point to the motor speed sensor, while bE2 and 6E2 are listed for a button that reads as stuck. Reading the exact characters on the display matters.

Can a heavy load cause bE?

A very heavy load can make the drum hard to turn, which may disturb the speed reading. Try a lighter load once, and call us if the code repeats.

Does the motor need replacing?

Not necessarily. The code points to the speed sensor signal, which can be a connection issue as well as a part. We test before recommending a replacement.

Book a visit

Still seeing bE / 6E?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 561-5298