Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Samsung specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 561-5298 Start a Repair
Model library · Samsung Range

NX58K9850SS

Samsung NX58K9850SS Slide-In Gas Repair

Start a Repair(713) 561-5298

Most common issues on this model

  1. Oven below its set temperature
  2. Uneven baking between the two oven sections
  3. Panel or knobs not responding
  4. Door latch or seal on the dual door
  5. Igniter glowing without lighting

The NX58K9850SS is an older Samsung 5.8 cubic-foot slide-in gas range with a Flex Duo oven and dual door, in stainless steel. It was built to sit flush between cabinets, so it is often found in a kitchen where the counters were fitted around it.

Uneven baking and an oven that does not reach its set temperature are the problems we hear about on gas ovens with a divider. We test the igniter’s draw and flame, the oven sensor and the divider seat, and we check that the dual door seals on both sections. A control panel or knobs that stop responding send us to the knob switches and the board supply.

Because this is a legacy model, we confirm the model and serial from the label and check the part before we order it. You get a written price before work and a 30-day workmanship warranty after.

Key features

  • 5.8 cu. ft. slide-in gas range
  • Flex Duo oven with dual door
  • Stainless steel finish
  • Gas cooktop and gas oven
→Codes

Error codes this model can show

-dE- / -dC-Samsung Range Message -dE- or -dC-: Partition Not Installed doorSamsung Range Message door: Door Not Closed tESt / tE5tSamsung Range Message tESt or tE5t: Demo Mode u (underlined)Samsung Induction Range Message u: Pan Detection bAd LinESamsung Range Message bAd LinE: Power Connection C-10Samsung Range Code C-10 (Self-Diagnosis): Usually Ignorable C-24Samsung Oven Heating Too Fast: Code C-24 Vent Check C-F0Samsung Range Code C-F0 (Electronics Link): Reset and Update
NX58K9850SSNX58K9850SS questions
The two oven sections bake unevenly. What do you check?

We test the divider's seat, the igniter and flame, and the oven sensor. Heat loss around a worn door gasket can also cause uneven results.

Is a slide-in gas range harder to pull out for service?

It needs clear access to the gas shutoff and a flexible connector. With room to pull it forward, we can test and reconnect safely. We also check that the anti-tip bracket is in place when we slide the range back into its cutout.

What if the control panel will not respond?

We test the board's supply, the panel connection and the knob switches. The board is replaced only if those are sound. If the board is the cause, we show the test result and the price before ordering it.

Book a visit

Book repair for your NX58K9850SS

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 561-5298