Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Samsung specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 561-5298 Start a Repair
Model library · Samsung Range

NX60T8751SG

Samsung NX60T8751SG Flex Duo Repair

Start a Repair(713) 561-5298

Most common issues on this model

  1. Control panel or smart dial not responding
  2. Self-clean cycle stopping early
  3. Flex Duo divider not recognized
  4. Oven heat uneven between sections
  5. Air Fry results uneven

The NX60T8751SG is an older Samsung 6.0 cubic-foot smart slide-in gas range with Flex Duo, a smart dial and air fry. It is sold with the NX60T8751SS on the same platform, so the label shows which finish and code yours carries.

A Flex Duo oven needs to read whether its divider is installed, so a section that heats unevenly or an oven that refuses to run can come from the divider contacts as well as the igniter. A smart dial or panel that does not respond sends us to the connector, the board’s supply and the wiring.

Self-clean must lock the door, so a cycle that stops partway points to the lock and its switch. We read the model and serial from the label before ordering a part, and we give you a written price before any work.

Key features

  • 6.0 cu. ft. smart slide-in gas range
  • Flex Duo oven
  • Smart Dial control and Air Fry
  • Also sold as NX60T8751SS on the same platform
→Codes

Error codes this model can show

-dE- / -dC-Samsung Range Message -dE- or -dC-: Partition Not Installed doorSamsung Range Message door: Door Not Closed tESt / tE5tSamsung Range Message tESt or tE5t: Demo Mode u (underlined)Samsung Induction Range Message u: Pan Detection bAd LinESamsung Range Message bAd LinE: Power Connection C-10Samsung Range Code C-10 (Self-Diagnosis): Usually Ignorable C-24Samsung Oven Heating Too Fast: Code C-24 Vent Check C-F0Samsung Range Code C-F0 (Electronics Link): Reset and Update
NX60T8751SGNX60T8751SG questions
The two oven sections heat unevenly. What do you test?

We check the divider seat and contacts, then the igniter and sensor for each section. We replace only what fails the test. If the divider is missing a seat or a clip, we replace that piece and retest both sections.

What does SG versus SS mean on this model?

The last letters show the finish, and the family shares a platform. We use the full label code for parts. Finish changes the trim, but the oven and board parts can be shared across the family.

My smart dial does not respond. Is the board bad?

Not necessarily. We test the dial connector and supply first, and replace the board only if they pass. A loose ribbon cable or a failed dial sensor can look like a dead board, so we confirm before ordering.

Book a visit

Book repair for your NX60T8751SG

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 561-5298